Sealer is what stands between your concrete and the weather. Over time it wears off, and the surface starts to fade, stain and soak up moisture. Re-sealing puts that protective layer back and brings the colour up at the same time.
We re-seal driveways, paths, pool surrounds and patios across Newcastle, cleaning the surface first so the new sealer bonds properly and lasts.
Get a Free QuoteA fresh seal keeps moisture and contaminants out, slowing the wear that leads to cracking and spalling.
Oil, rust and organic stains sit on top of a sealed surface instead of soaking in, so they clean off.
Re-sealing lifts faded, dull concrete and brings back its colour and finish.
A sealed surface repels water, which helps in shaded, damp spots prone to mould and algae.
A sealer is only as good as the surface it goes onto. We clean the concrete thoroughly, let it dry, then apply the right sealer for the surface and the way you use it, so the finish bonds well and holds up.
We check the condition, note any repairs needed and recommend the right sealer.
Pressure clean the surface to strip dirt, old flaking sealer and organic growth.
Allow the concrete to dry fully so the new sealer can bond as it should.
Apply an even coat of the appropriate sealer for a protected, refreshed finish.
As a rough guide, every three to five years, though a busy driveway in full sun may need it sooner. If water no longer beads on the surface, it is time.
Yes. Decorative concrete relies on its sealer for both protection and appearance, so re-sealing is especially worthwhile on coloured and stamped surfaces.
We assess the surface first and can address minor cracks and stains as part of the prep so the finished result looks its best.
Most sealers are touch-dry within a few hours and ready for foot traffic the same day. We will advise the exact times for the sealer we use and when it is safe to drive on.
Tell us what needs sealing and we will arrange a look and a free, no-obligation quote.
Get a Free Quote